For bonding moldings, ceiling tiles, wall underlays and decorative rosettes in polystyrene or polyurethane.
Supports:
- Porous supports, eg brick, concrete, plaster and wood.
- Condition: Clean, dry, degreased.
- Surface preparation: first apply a coat of primer on very porous surfaces. It is advisable to carry out an adhesion test on any surface.
Application:
- With a comb. Spread the glue on the support, on a surface that can be covered within 15 minutes. Spread the glue on the molding.
- Lay the molding and then press. Heavy or tensioned materials must be clamped or supported.
- The glued material can be used after approximately 24-48 hours.
- Application temperature: +5 °C to +35 °C
- Cleaning product: Before drying, use water, after drying only mechanically.
Technical properties:
- Measured at 20°C / 65% (relative humidity).
- These values may vary depending on environmental factors such as temperature, humidity and nature of the substrate.
Material Synthetic dispersion
Consistency Pasty
Color White
Curing system Physical polymerization
Open time ± 15 to 20 minutes
Drying time ± 24 hours
